| 李承觊,张德远.离心旋流式喷嘴雾化特性实验研究[J].装备环境工程,2016,13(6):47-51. 李承觊,张德远.Research on atomizing properities of Centrifugal swirl nozzle[J].Equipment Environmental Engineering,2016,13(6):47-51. |
| 离心旋流式喷嘴雾化特性实验研究 |
| Research on atomizing properities of Centrifugal swirl nozzle |
| 投稿时间：2016-03-19 修订日期：2016-11-17 |
| DOI：10.7643/ issn.1672-9242.2016.06.009 |
| 中文关键词: 低温多效蒸馏 雾化特性 雾滴粒径分布 喷淋密度 |
| 英文关键词:low-temperature multi-effect distillation atomizing properities droplet size distribution sprinkle density |
| 基金项目: |
|
|
|
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 目的 进一步优化低温多效蒸馏技术中的喷淋布液方式，提高海水淡化换热效率。方法 采用马尔文激光粒度分析仪、高速摄像机和翻转水量仪对不同口径的CJ-9型离心旋流式喷嘴进行研究。结果 同一口径的喷嘴，随着水流压力的增加，液滴粒径分布的均匀性显著提高。随着水压的增加，同一个喷嘴液体破碎的纹路变密，同时液膜破碎的长度变短，破碎效果越好，雾化性能越好。同一口径的喷嘴，入口压力越大，其边缘流峰值越高，空心化率现象越明显。同一压力下不同口径的喷嘴，口径越大，其形成双波峰的跨度越短；同一口径的喷嘴，入口压力越大，其形成双波峰的跨度越长，其边缘流峰值越高。结论 液滴粒径分布的均匀性随着水压的增加或孔径的减小而显著提高，喷淋密度在直径方向上存在两个峰值，运用“峰谷叠加”原理，来满足低温多效蒸发器布液均匀的整体要求。 |
| 英文摘要: |
| Purpose Optimizing the sprayed method in LT-MED system, improving the heat exchange efficiency of seawater desalination. Method Malvern Spray droplet analyzer, high-speed camera and auto overturn water meter were used to research the centrifugal swirl nozzle CJ-9 with different diameter. Result At the same diameter of the nozzle, droplet size distribution of the uniformity was significantly increased with the increase of water pressure. With the increase of water pressure, the liquid breakage of the same nozzle becomes dense, and the length of the broken liquid film becomes shorter, the crushing effect was better, the atomization performance was better. The higher the inlet pressure was, the higher the peak value of the edge flow was, the more obvious the hollowing rate was. At the same pressure, the larger the diameter of the nozzle, the shorter the span of the formation of double-crest; at the same diameter of the nozzle, the greater the inlet pressure, the longer the span of the formation of double crests, the higher the edge flow peak. Conclusion The uniformity of droplet size distribution was significantly improved with the increase of water pressure or with the decrease of the diameter of the nozzle. Spray density had two peaks in diameter direction, the principle of superposition of "peak valley" could be used to meet the uniformity needs of LT-MED system. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
