| 焦冀光,杨春,刘文一.潜艇发射筒保护盖力学性能分析[J].装备环境工程,2017,14(4):87-90. JIAO Ji-guang,YANG Chun,LIU Wen-yi.Mechanical Property of Submarine Launch Canister Protection Cover[J].Equipment Environmental Engineering,2017,14(4):87-90. |
| 潜艇发射筒保护盖力学性能分析 |
| Mechanical Property of Submarine Launch Canister Protection Cover |
| 投稿时间：2017-01-20 修订日期：2017-04-15 |
| DOI：10.7643/ issn.1672-9242.2017.04.018 |
| 中文关键词: 发射筒 潜艇 保护盖 |
| 英文关键词:launch canister submarine protection cover |
| 基金项目: |
|
|
|
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 目的 研究艇载发射筒保护盖在深水压力和温度载荷下的力学性能。方法 建立保护盖力学载荷和温度载荷模型，采用有限元技术仿真计算保护盖在这些载荷下的形变、应力、温度分布和热结构情况。结果 深水压力载荷作用下，保护盖出现的形变大小在0.977~1.47 cm范围内，应力大小在1.22~7.91 MPa范围内。温度载荷下出现的形变大小在0.92~1.38 cm范围内，应力大小在0.272~1.26 MPa范围内。结论 两种工况下保护盖最大形变均出现在中部，因此这个部位结构强度需加强，以防其被破坏。 |
| 英文摘要: |
| Objective To study mechanical properties of submarine launch canister protection cover under deepwater pressure and temperature load. Methods Model for mechanical and temperature load of protection cover was established. Finite-element method was used to analyze the stress, deformation, temperature distribution and thermal structure under those loads. Results Under deep water pressure, the deformation was 0.977 cm to 1.47 cm, the stress was 1.22 MPa ~ 7.91 MPa. Under temperature load, the deformation of the protection cover is 0.92~1.38 cm and the stress was 0.272 kPa ~ 1.26 MPa. Conclusion The maximum deformation of protection cover was on centre portion in two working conditions, so the structural strength of centre portion should be reinforced, otherwise it would be damaged. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
