| 刘兴强,黄文超,郭定文,延浩,宁方立.含弹内埋弹舱缩尺模型气动噪声特性研究[J].装备环境工程,2018,15(9):7-11. LIU Xing-qiang,HUANG Wen-chao,GUO Ding-wen,YAN Hao,NING Fang-li.Characteristics of Aerodynamic Noise in Scale Model of Weapon Bay[J].Equipment Environmental Engineering,2018,15(9):7-11. |
| 含弹内埋弹舱缩尺模型气动噪声特性研究 |
| Characteristics of Aerodynamic Noise in Scale Model of Weapon Bay |
| 投稿时间：2018-06-25 修订日期：2018-09-25 |
| DOI：10.7643/ issn.1672-9242.2018.09.002 |
| 中文关键词: 空腔噪声 气动噪声计算 噪声仿真 |
| 英文关键词:cavity noise computation of aerodynamic noise noise simulation |
| 基金项目: |
|
|
| Author | Institution |
| LIU Xing-qiang | 1. AVIC Aircraft Strength Research Institute, Xi'an 710065, China |
| HUANG Wen-chao | 1. AVIC Aircraft Strength Research Institute, Xi'an 710065, China |
| GUO Ding-wen | 1. AVIC Aircraft Strength Research Institute, Xi'an 710065, China |
| YAN Hao | 1. AVIC Aircraft Strength Research Institute, Xi'an 710065, China |
| NING Fang-li | 2. Northwestern Polytechnical University, Xi'an 710072, China |
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 目的 对含弹的内埋弹舱模型进行噪声仿真和试验研究。方法 计算采用“CFD+CAA”的混合方法，采用DDES计算流场，基于Möhring声学类比方法得到测量点的噪声信息。采用该方法与空腔M219标准试验结果进行对比。内埋弹舱吹风试验在全消声室中进行，并采用传声器阵列识别主要噪声源。结果 计算与试验得到的不同来流条件下，不同测量点的噪声频谱曲线基本一致。弹舱内最大声压级出现在中间弹翼附近的侧壁上，与声源识别的主要噪声源的位置一致。结论 该研究可为内埋弹舱的设计提供参考和技术支持。 |
| 英文摘要: |
| Objective To perform simulation analysis and experiment research on noise of a weapon bay. Methods “CFD+CAA” as well as DDES were used to calculate the flow field. Then based on the Möhring acoustics analogy method, information on noise at the measuring spot was obtained. This method was compared with the result of cavity M219 standard test. The blowing test of the weapon bay was carried out in a full anechoic chamber and main noise sources were identified with a microphone array. Results The curves of noise spectrum in different measuring spots are basically in line with each other under different flowing conditions obtained in computation and experiment. The maximum sound pressure level of the weapon bay appeared at the side wall around middle missile wing, this is in line with the position of the main noise source of sound source identification. Conclusion The study can provide reference and technical support for design of weapon bay. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
