| 胡博,陈平玭,邓明.可靠性仿真试验在机载电子产品上的应用[J].装备环境工程,2021,18(12):31-36. HU Bo,CHEN Ping-ping,DENG Ming.Application of Reliability Simulation Test in Airborne Electronic Products[J].Equipment Environmental Engineering,2021,18(12):31-36. |
| 可靠性仿真试验在机载电子产品上的应用 |
| Application of Reliability Simulation Test in Airborne Electronic Products |
| 投稿时间：2021-04-19 修订日期：2021-06-15 |
| DOI：10.7643/issn.1672-9242.2021.12.006 |
| 中文关键词: 可靠性仿真试验 可靠性评估 机载电子产品中图分类号:V21 文献标识码:A 文章编号:1672-9242(2021)12-0031-06 |
| 英文关键词:reliability simulation test reliability evaluation airborne electronic products |
| 基金项目: |
|
|
|
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 可靠性仿真试验技术作为可靠性设计重要工作之一，因其周期短，经费少，效果明显，现在被广泛应用在产品研发过程中。主要研究了可靠性仿真试验技术在机载电子产品上的应用，通过简要介绍可靠性仿真试验原理、基本流程、试验方法、试验对象选取原则等，并结合实际工程应用，证明了该技术对于机载电子产品早期研发过程设计质量提升具有积极推动作用。相比于传统的实物参与的可靠性试验主要解决后端暴露的问题，该技术面向设计前端，通过可靠性仿真试验技术得出的机载电子产品可靠性评估结果，可以使机载电子产品在方案阶段或下图制造前存在的薄弱环节和潜在故障，得到提前释放，同步优化设计，切实提升产品可靠性水平。同时，该技术也可以满足现阶段机载电子产品研制进度紧，资源有限的研制需求。 |
| 英文摘要: |
| As one of the important work of reliability design, reliability simulation test technology is widely used in product research and development because of its short cycle, low cost and obvious effects. This paper mainly studies the reliability simulation test technology in the application of airborne electronic products, through the brief introduction of the principle of reliability simulation test, the basic flow, test method, and test object selection principle, connecting with the actual engineering application, shows that the technology for airborne electronic products in the early development process design quality improvement has a positive role in promoting. Compared to the traditional physical in the back-end exposure of reliability test is mainly to solve the problem, the technology faces the front-end design, through the reliability simulation test technology of airborne electronic products reliability evaluation results, can release the weak links and potential failures of below airborne electronic products in the solution phase or before manufacturing, optimize design synchronously, and improve product reliability. As the same time, the technology can also meet the development requirements of the current stage of the development of airborne electronic products in a tight schedule and limited resources. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
