|
| Mechanical Analysis and Testing of Rotary Arm System of TLJ-60A Geotechnical Centrifuge |
| Received:July 24, 2015 Revised:October 10, 2015 |
| View Full Text View/Add Comment Download reader |
| DOI：10.7643/issn.1672-9242.2015.05.006 |
| KeyWord:geotechnical centrifuge rotary arm strength numerical simulation test |
| Author | Institution |
| YU Shao-rong |
Institute of Systems Engineering，CAEP，Mianyang ，China |
| DU Qiang |
Institute of Systems Engineering，CAEP，Mianyang ，China |
| LI Xin-yao |
Institute of Systems Engineering，CAEP，Mianyang ，China |
| WANG Jun |
Institute of Systems Engineering，CAEP，Mianyang ，China |
|
| Hits: |
| Download times: |
| Abstract: |
| Objective To evaluate whether the rotary arm system of TLJ-60A geotechnical centrifuge can meet the strength requirement and give some suggestions. Methods The 3-dimensional finite element numerical model was built and the boundary and load conditions were determined. Then the maximum equivalent stresses in key locations of the rotary arm system were calculated and a suggestion on the material selection was given. After the centrifuge assembling, the strains of the corresponding locations were tested in a working condition. Results It showed that the numerical results agreed well with the test results. The mean difference was 4.5%, the maximum difference was 12.46%; and the numerical results were conservative. Conclusion The evaluation and the suggestions were correct, which supported the one-time success of the equipment. |
| Close |